
iPad 2: shutting down with charge left
A customer from Astana brought in an iPad 2 that kept shutting down even though the battery still showed half full. We replaced the battery and checked charging — it now holds and runs steadily.
Your iPad 2 dies faster than you can use it — we replace the battery in two hours, original or aftermarket, and your data stays on the tablet.

When an old iPad 2 needs a new battery: it holds charge for minutes, the percentage jumps, the back runs hot and the glass has lifted.
The tablet lives on the mains: unplug the cable and it goes dark within minutes, or at once.
The gauge drops in leaps, shows a full charge, then suddenly plunges to zero.
The rear panel warms noticeably while charging, although the device is doing nothing demanding.
A gap or bulge has appeared at the screen edge: the battery has swollen and the tablet must not be switched on.
The price of the work on an iPad 2 is shown below; the technician picks an original or aftermarket cell to suit the device.
| Service | Original | Aftermarket |
|---|---|---|
| Battery replacement | 30 900 ₸ | 17 900 ₸ |
| Charging port replacement | 24 900 ₸ | 13 900 ₸ |
| Display replacement | 44 900 ₸ | 27 900 ₸ |
| Display glass replacement | 24 900 ₸ | 13 900 ₸ |
| Main camera replacement | 24 900 ₸ | 13 900 ₸ |
| Front camera replacement | 31 900 ₸ | 17 900 ₸ |
| Home button replacement | 24 900 ₸ | 13 900 ₸ |
| Button replacement | 24 900 ₸ | 13 900 ₸ |
| Speaker replacement | 29 900 ₸ | 16 900 ₸ |
| Microphone replacement | 24 900 ₸ | 13 900 ₸ |
| Flex cable replacement | 21 900 ₸ | 15 900 ₸ |
| Housing replacement | 40 900 ₸ | 22 900 ₸ |
| Other repairs | Price | |
| Water damage cleaningcorrosion cleaning · diagnostics up to 2 days | 10 900 ₸per job | |
| Logic board repairmicrosoldering · 1–3 days | 33 900 ₸per job | |
| Wi-Fi module repairwireless module · board-level repair | 16 900 ₸with parts | |
| Firmware flashingsoftware restore, no parts replaced | 8 900 ₸per job | |
The technician confirms the final sum after inspection, once the state of the case, screen and battery is visible.
The stages of the swap: examining the tablet, choosing a cell, lifting the screen, removing the old battery, connecting the new one and testing.

The technician checks how the charge behaves, looks over the case and glass, and searches for signs of swelling.

An original or aftermarket battery is chosen for the iPad 2, and the gap in capacity and lifespan is explained first.

Glass on an old tablet is fragile, so the adhesive is warmed and the screen eased up slowly without pressing the edges.

Adhesive strips are released carefully so the cell is not deformed and the board beside it is spared.

The new battery is laid in place, plugged into the board, and its contacts are checked for a firm fit.

The screen goes back, the tablet is switched on, and charging and running without the cable are observed.
The old tablet works again without being tied to a socket.
Price for my modelFor a device of this age original parts are rarer, and an aftermarket cell can be a reasonable alternative.


How our service helps owners of veteran tablets: we know older models, keep the talk to the point and treat the glass with care.
Eleven years of repairs have taught us about earlier-generation devices with brittle glass and stubborn adhesive.
The finished work carries a warranty up to 1 year, and the technician states the terms before the replacement.
The work is done by experienced technicians who know how to open an old tablet safely.
The technician tells you honestly how worthwhile a replacement is for your use and does not advise anything extra.
If the screen sits on the edge of cracking when opened, we warn you before the work begins.
Mon–Fri 10:00–19:00, weekends and holidays 11:00–18:00, so a visit fits on a day off.

A customer from Astana brought in an iPad 2 that kept shutting down even though the battery still showed half full. We replaced the battery and checked charging — it now holds and runs steadily.
Usually the whole journey — from message to pickup — takes less than an hour; complex repairs follow the timeline in the receipt.
Book a repairYou send a photo of the damage on WhatsApp — we quote the price and available time. Or you call a courier.
An engineer checks the device in front of you and shows what is broken. 0 ₸, even if you decline the repair.
We fix the price, the part (original or analog), the timeline and the warranty. You sign — we start.
Before installation we show you the new part in its factory packaging. You wait in the waiting area with coffee and Wi‑Fi.
Screen and touch, Face ID or Touch ID, cameras, microphones, speakers, charging, Wi‑Fi. You check together with the engineer.
Together with the receipt, warranty card and the old part. Payment — Kaspi, card or cash.
Technicians for iPhone, Mac, iPad, Apple Watch and AirPods repair.
Photo: Bakmukhammed S.
Photo: Galymzhan S.
Photo: Zhandos Sh.
Photo: Darkhan T.
Photo: Kudiret S.A new screen goes in if the glass cracks or the touch layer glitches.
02We replace the port if the cable sits loosely or charging cuts in and out.
03The button is brought back to life if it sticks or will not press.
04The board and power are checked to find hidden causes of faults.
05A new speaker is fitted if the sound is quiet or crackling.
06Boards are cleaned if liquid or condensation has reached them.

“If the repair didn’t suit you or you have a complaint, write to me personally.”
Send a photo of the screen and the iPad model. An engineer will reply on WhatsApp, give the price and today's available time.
iPad 2 Battery Replacement in Astana for Everyday Use
iServices handles iPad 2 battery replacement in Astana with our own technicians, not through a middleman. We open the glued front glass and swap the cell for an original part or an aftermarket one. The price, part and warranty are fixed on the receipt before work starts, and every repair carries a warranty up to 1 year.
The iPad 2 is the oldest tablet people still bring to us, and whether it deserves a fresh cell depends on what it does in the house today, not on the age printed on the back.
We tell customers straight when a cracked screen plus a dead battery on an iPad 2 adds up to more work than the tablet is worth to them. A failing 30-pin port, a power controller that no longer charges reliably, or a board fault on top of a tired battery turns a simple swap into a multi-stage job, and we name that before quoting. Our engineers run a free 15-minute check in front of you and show exactly which component has failed, so the decision rests on evidence rather than guesswork. On the units we see, the battery alone is usually the whole story.
iPadOS has no battery health screen like the iPhone, so owners read the symptoms instead. Here is what the behaviour of an aging iPad 2 actually tells you.
If the iPad 2 does not charge at all, we test the cable, the block and the 30-pin port first, then the battery and the charging controller on the board. A dirty or worn connector is common at this age, and a bench power supply shows within minutes whether current reaches the pack. Our free diagnostics take 15 minutes in front of you, so the verdict comes before any part is ordered. A tablet that charges but drains while asleep usually points at software or a background app, not the battery — reinstalling or checking usage costs nothing and saves a needless swap. When the port and controller test clean, we quote a replacement on the spot, and the part, turnaround and warranty are fixed on the receipt before work begins.
On the iPad 2 the cell sits under a front glass that is glued into the aluminium frame. That single fact shapes the whole job and the main risk in it.
We reach the battery only after heating and lifting the glued front glass, so the delicate part of the job is the glass, not the battery itself. The digitizer and the LCD sit directly above the battery, and the frame adhesive runs around the whole perimeter, which is why the panel has to come off evenly rather than at one corner. On the iPad 2, 3 and 4 the battery is not serviceable from the back — the rear shell is a single sealed plate, so the only route in is through the front. We warm the display on a heating platform until the adhesive softens, then work around the edge with thin plastic tools and never with metal. Gentle, even heat and plastic tools keep an intact screen intact — prying cold glass is exactly how a working display turns into an extra repair.
Two paths are open for an iPad 2, and the right pick depends on how hard the device will be worked and how many years you intend to hold on to it.
| Option | Expected lifespan | Charge indicator | Best for |
|---|---|---|---|
| Original cell | Longest, closest to factory | Accurate percentage | Daily work, long ownership |
| Quality aftermarket | Shorter, fine for light loads | May drift slightly | Occasional use, a child's device |
| Mixed choice | Depends on the pack fitted | Drifts only under heavy load | Budget with moderate use |
Before any work starts we write the component, the turnaround and the warranty up to 1 year onto the receipt, so the choice you make is the choice you get. That takes about 2 minutes and settles what happens if the power pack misbehaves later. Keep the paper with the warranty card — it is what a claim is checked against and the only document naming the exact unit fitted. 64% of customers pick an original part, mostly because they plan to hold the hardware for years rather than months. The rest weigh the saving against lighter daily loads and accept a shorter service life.
From the first photo to the handover, the iPad 2 battery replacement in Astana usually fits into a single visit. Here is the order things happen in.
A battery job runs from 1 hour to 1 day, and most customers wait in our lounge with coffee and Wi-Fi while it is done. The swap itself does not erase data, though a backup and your passcode noted down turn a rare glitch into a non-event. iPadOS keeps the same apps and settings after the battery is changed, so you pick up where you left off. Bring the device charged if you can — a flat pack makes the first charge test slower. A courier can be called if you would rather not travel across the city. The jobs that go smoothest are the ones where the owner arrives with a fresh backup and a known passcode, not a guess at what it might be.
After the swap we run a 32-function check of about 10 minutes with you watching, covering charging, speakers, cameras, microphones and network. You test the same list together with the engineer, so nothing is signed off until you have seen it work. The device comes back with the receipt, the warranty card covering it up to 1 year, and the old battery. Keeping the old part lets you see for yourself what was replaced and compare it with the new one. Expect the first charge cycles to read a little uneven — that settles after a few full charges. If anything feels off in the first days, message the same WhatsApp thread and an engineer picks it up.
The whole picture fits into five points: how wear shows up, what the glued glass changes, why a swollen cell is urgent, how the two part options differ, and what happens to your data.
Did not find an answer? Message us on WhatsApp: an engineer replies, not a bot.
Ask a questionYes, if you use it as a reader, player or kitchen screen. The old system does not suit modern apps and games, and it is better to know that in advance.
Yes, glass on old tablets is brittle, and there is a risk even with careful work. The technician warns you in advance and works cautiously, warming the adhesive.
Do not switch on or charge the tablet, and do not press the screen. Put it on a non-flammable surface and show it to a technician as soon as possible.
Rarely, so availability must be checked in advance. If there is no original, the technician offers an aftermarket cell and explains the difference.
The battery is rarely the cause of slow charging: usually it is a weak phone adapter or a frayed dock cable. Try a tablet adapter first, and if the speed does not improve, ask the engineer to check the dock connector.
It can, but keeping the cell at full charge all the time ages it faster, and the old iOS on the iPad 2 has no charging optimisation. Unplug it from time to time and let the level drop before topping up again.
No, modern lithium cells do not need a special break-in. Just use the iPad 2 as usual for a few days; the percentage display settles on its own after a couple of full cycles.

Most charging faults come from the cable, the port or the battery. Here is how to tell which one and what to do next.

On most iPads the glass, touch layer and display are one sealed module, so a glass-only swap is often impossible. An engineer confirms it for your model.

Decide whether to fix or replace your old iPad with a clear look at costs, turnaround and part options.

A case with raised edges, tempered glass and a few tablet settings keep a child's iPad intact.

Back up your data, turn off Find My, and bring proof of purchase — then the repair starts faster.